The air-cooled Porsche 911s with dry sump lubrication were equipped with a larger volume of motor oil compared to the water-cooled variants. The air-cooled models typically had a total oil capacity of around 10-12 quarts, while the water-cooled versions had a smaller oil capacity of around 8-9 quarts. This larger oil capacity in the air-cooled models helped to ensure better cooling and lubrication for the engine, especially during high-performance driving. **

A licensed and experienced plumber or HVAC technician is typically responsible for connecting an oil stove with a central oil supply. These professionals have the necessary skills and knowledge to safely and correctly install the necessary piping and connections to ensure the oil stove functions properly. It is important to hire a qualified professional to perform this task to prevent any potential safety hazards or issues with the oil stove in the future. **

Dry sump lubrication is advantageous for lowered cars because it eliminates the need for an oil pan, which is typically the lowest point of the engine and susceptible to damage from speed bumps, potholes, or other road hazards. By removing the oil pan, the risk of it being damaged is significantly reduced, allowing lowered cars to navigate uneven roads without worrying about oil pan damage. Additionally, dry sump systems provide better oil control and lubrication efficiency, which can be beneficial for high-performance engines often found in lowered cars. **

To connect a wood-burning stove to an oil chimney, you will need to install a stainless steel chimney liner that is suitable for use with both wood and oil. The liner should be properly sized to fit the stove and the chimney, and it should be insulated to prevent heat transfer to the surrounding walls. It is important to follow the manufacturer's instructions for installation and to ensure that the chimney is cleaned and inspected regularly to prevent any buildup of creosote or other debris. Additionally, it is recommended to consult with a professional chimney installer to ensure that the installation is done safely and correctly. **

To remove a tankless water heater and connect it to an oil heating system from 1960, you will first need to turn off the water and power supply to the tankless water heater. Next, disconnect the water lines and gas supply to the tankless water heater. Then, you can connect the water lines to the oil heating system and ensure that the system is properly set up to provide hot water. It is recommended to consult a professional plumber or heating technician to ensure the proper installation and connection of the systems. **

To remove the instantaneous water heater and connect it to an oil heating system from 1960, you will first need to turn off the water and power supply to the water heater. Next, disconnect the water heater from the plumbing and electrical connections. Then, connect the oil heating system to the existing plumbing lines and electrical supply where the water heater was previously connected. It is recommended to consult with a professional plumber or heating technician to ensure the proper installation and connection of the oil heating system. **

Water will freeze more easily into ice compared to oil and cooking oil. This is because water has a higher freezing point than oil and cooking oil. When the temperature drops below 32°F (0°C), water will start to freeze and form ice, while oil and cooking oil will remain in liquid form. Therefore, water is more likely to freeze into ice at lower temperatures compared to oil and cooking oil. **

Water alone is not enough to effectively remove oil from surfaces. Oil and water do not mix due to their different chemical properties, so simply using water will not break down or remove the oil. To effectively remove oil, a detergent or soap is needed to break down the oil molecules and allow them to be washed away with water. **